The FI1500 flow indicators should not be installed in circuits where… $1,369.25 – $1,555. The piston is magnetically coupled to the rotary pointer assembly which registers on a clear 2 1/2” (63 mm) scale displayed in US GPM and LPM. Flow range: 100 cc/min to 189 litters/min (0 to 50 gym) Accuracy (at 30cp): ± 0.2 of reading over 50:1 range Maximum Operating Pressure: 35,105 or 240 bar (500, 1500 or 3500 psi) Displacement: 0.062 litters/rev (3. Start the motor or engine that powers the hydraulic pump. Open the flow control valve all the way on the test meter. Connect the test flow meter to the discharge of the pump. The piston movement is directly proportional to flow rate and the sharp edge orifice minimizes the effects of viscosity. Hydraulic Flow Meters Hydraulic Flow Meters. Disconnect all components / hoses from the pump discharge port except for the system relief valve on a fixed displacement pump. The flow indicator consists of a sharp-edged orifice and tapered metering piston. The flow indicator design ensures good reliability and minimizes the effects of contamination. These direct-acting flow indicators can be installed in hazardous areas or on applications where no power is available. Also, lubrication and coolant systems using oil. They can be used on mobile and industrial hydraulic circuits. The large clear 63mm diameter dial ensures that quick checks can be made to determine pump performance and the setting of flow control valves. The FI750 flow indicators should not be installed in circuits where the flow is reversed.įlow Indicators are designed for continuous monitoring or intermittent use commissioning and servicing hydraulic systems up to 5000 PSI, 345 bar. The piston is magnetically coupled to the rotary pointer assembly which registers on a clear 2-1/2″ (63 mm) scale displayed in Lpm and US GPM. The piston movement is directly proportional to flow rate and the sharp edge orifice minimizes the effects of viscosity. The flow indicator consists of a sharp edged orifice and tapered metering piston. The flow indicator design ensures good reliability and minimizes the effects of contamination. These direct acting flow indicators can be installed in hazardous areas or on applications where no power is available. Also lubrication and coolant systems using oil. They can be used on mobile and industrial hydraulic circuits. The large clear 2-1/2″ (63 mm) diameter dial ensures that quick checks can be made to determine pump performance and setting of flow control valves. Other fluids consult sales office.Flow Indicators are designed for continuous monitoring or intermittent use commissioning and servicing hydraulic systems up to 6000 psi (420 bar). The Flo-tech Portable Hydraulic Tester simultaneously measures the flow rate, temperature and pressure of hydraulic fluid. Hydraulic Flow Test Meter Kit Usa Made Stauff, 15-150lpm 3500psi.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |